The Erasan range of heavy duty coil winders require a guide head system suitable for the application to be wound, many factors influence the choice of guide head, from wire size to wire type / profile etc.

Shown below is the single profile wire guider, however please do ask your local agent if you require a custom solution.

The front roller is also adjustable in height / angle. This “negative effect” roller can be used to produce an upward curve on the wire.

When wound onto the flat sides of the bobbin the inverse curve of wire presses against the long flat edges of the bobbin, reducing the bow effect

The guide head angle is adjustable;

Course adjustment in steps of 18°

Fine adjustment from bolt underneath

The guide head has four profile rollers - adjustable width & wire insulation protecting Teflon side walls, as well as outer “V” groove roller for round wire